BatteryMINDers RFP™ circuitry allows the OnBoard desulfator to sweep the entire frequency range known to cause sulfation crystal molecules to resonate, un-bond, and then safely dissolves them. The sulphuric acid, the main component in the sulfate crystals, is now free and returns to the battery’s electrolyte. As a result, the Specific Gravity (S.G.) of the electrolyte is now higher and able to generate more electrical energy-storage capacity, than the previously sulfated batteries. Considerably less charging-source energy (solar panels, generators, alternators, et al) and much faster recharge, to full capacity, can now be expected. This is significant in “off the grid” solar installations when solar exposure times are short and / or power demands are high.

Golf car and RV owners who do not use their units, for months at a time, will benefit significantly from OnBoard desulfation. When used simultaneously, with the original factory supplied golf-car charger or built-in RV converter-charger, our OnBoard units continuously “clean” the battery’s charge plates. With sulfate-free plates the reduced performance and life shortening affect of long-term storage will be minimized. Although this OnBoard unit does not charge or maintain batteries, by enabling the batteries to accept full charges, each time they are recharged, the damaging affect of long-term non-use are significantly reduced. The use of a safe, maintenance charger is always recommended when extended storage is anticipated.

Note: The great majority of golf car factory supplied chargers turn off when batteries are supposedly fully charged. If they are sulfated, they cannot be recharged to 100%, until or unless they are de-sulfated. RV converters with a charger stage are notorious for overcharging batteries, when left on for long non-use periods. They too cannot charge sulfated batteries to 100% of their capacity.

Additional advantages of using sulfation-free batteries include eliminating or greatly reducing the need for “equalizing” deep-cycle flooded (filler-caps) batteries, reduced recharge time, while demanding less output energy from solar arrays. In fuel powered vehicles extended alternator and belt life can be expected, as the vehicle’s charging system no longer needs to work as hard trying to charge batteries that will not accept high alternator output current due to sulfation build-up. Better fuel economy can also be expected, as much lower amperage is now demanded from the alternator to keep clean, sulfate-free batteries fully charged. Lower alternator output current demands, translates to lower engine loads.

BatterMINDer guarantees to significantly increase both your battery’s life and performance or they will refund 100% of your money within one (1) full year. This is in addition to the five (5) year “no hassle” warranty.

What it does is it organizes your cord into two seperate flexible chambers, one for each half. This allows you to access either end independently, and at all times.

You can plug it in, go to work, and it unreels as you work. It winds up easily, because the ends wind past, not over each other, so they don’t tangle. It works on anything flexible – extension cords, air hoses, flat cords, all the RV items like fresh water hose, antenna cables, and power cords.

The CP-100 and CP-XL units are made out of the same material as pickup truck bed liners. They are formulated for outdoor use – good to minus 100 degrees.

-Sleek Design for easy Portability with wheel kits included on many models

- Super Quiet operation from 58 dB.  Great for Camp Grounds

- Power Status Lites for all models

- Low-Oil Shutdown for Maximum Engine Protection

- Insulated Case Construction for extra Quiet Operation

- Required Exhaust Spark Arrestor installed for safe operation in National Parks

Features
1) Unmatched in Durability – In Fact, You Can Even Walk On It!

Our panel can withstand hail storms and other weather including extreme heat and cold. (Most hard panels will melt the crystal in extreme heat.) In fact if you were to damage any section of the panel it will only affect that panel in our mat. Crystalline panels cannot be walked on thus restricting your roof access and also will crack and break in some extreme weather including hail storms.

2) Greater Efficiency – Draws Power for Longer Periods Throughout the Day

The Flex Power Mat is composed of 3rd generation, triple junction amorphous silicone, which means that our panel gathers all three rays of light. This allows it to draw power from the sun at lower angles and for longer periods throughout the day.

The Flex Power Mat generates 68Watts, 4.1AMP’s and 16.5Volts but is capable of producing more energy over the course of a day than crystalline panels with higher wattage due to flush mounting the crystalline panel on the roof of your RV. Crystalline panels can lose up to approximately 40% of their energy production capability by not having them angled to the sun. As we know, most people leave have their panels mounted flush on the roof and do not angle or tilt them to the sun throughout the day.

3) The Flex Power Mat Even Draws Power In the Shade!

The Flex Power Mat has Bypass Diodes and is Shadow Tolerant, which means that it has more efficient energy production even on overcast/dull days. Most crystalline panels when shadowed even 25% will not be producing power. Our panel produces power even when shaded by trees. So feel free to park at your favorite location and not have to worry about your panel producing power.
 

4) Ultra Low-Profile, Aerodynamic Design

The Flex Power Mat creates no wind chatter when traveling and its low-profile, aerodynamic design is perfect for resistance in high winds. This low-profile design also means that it is aesthetically pleasing on your roof, unlike bulky, non-aerodynamic crystalline panels. Our panel also creates no wind drag or wind load when traveling. With the Flex Power Mat, you never have to worry about climbing up and down on your roof to adjust or lock down your panel before or after traveling.